![]() In a few moments you can (mostly) throw measures out the window, but for these ten tubes try to be delicate. Also try to make both ends as flat as possible-using a miter box really helps-to reduce wiggle in your table. These are the only tubes where the length really matters. To make a 28" high table, start by sawing 10 tubes to a length of 28." To make a table of length x, cut 10 tubes to length x. You can decide how tall you want your table to be. ![]() ![]() Start cutting the main support tubes I wanted to make a table 28" high. I think that's it!Īll in all, cutting the tubes was perhaps the most time consuming step-though not the most frustrating, that will come later. Some optional tools and supplies include: Paint and method for applying paint Plexiglass or corruguated cardboard to make a flat top surface for the table A coping saw (for cutting the plexiglass) An exacto knife Okay. A measuring tape or other measuring device. String or twine of some sort-I used some cotton yarn remnants from my ex-girlfriend's knitting project (with her permission of course! We are on good terms!). (Optional but really kind of important ) A miter box. If you use Gorilla Glue you should also have a sponge and water source handy to dampen the materials before applying glue. Gorilla glue-You can probably use another kind of glue, but I had this lying around and for some reason I felt like using it. Between 15 and 20 cardboard tubes measuring 56" long and with wall thickness of approximately 1/8." If substituting mailing tubes make sure you have a lot of them.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |